Nokia 7650 - Access points

Copyright © 2002 Nokia. All rights reserved.

Se

tt

ing

s

33

•

User name

- Write a user name if required by the service provider. The user name may

be needed to make a data connection, and is usually provided by the service provider.
The user name is often case-sensitive.

•

Prompt password

- If you must key in a new password every time you log on to a server,

or if you do not want to save your password to the phone, choose

Yes

.

Tip! When you are

writing, press

to

open the special
characters table. Press

to enter a space.

•

Password

- A password may be needed to make a data connection, and is usually

provided by the service provider. The password is often case-sensitive. When you are
writing the password, the characters you enter are shown briefly and then changed to
asterisks (*). The easiest way to enter numbers is to press

and select

Insert number

and then continue entering letters.

•

Authentication

-

Normal

/

Secure

.

•

Gateway IP address

- The IP address that the required WAP gateway uses.

•

Homepage

- Depending on what you are setting up, either write

• the WAP service address, or
• the address of the multimedia messaging centre.

Glossary: ISDN

connections are a way to
establish a data call
between your phone and
your access point. ISDN
connections are digital
from end to end and as
such offer quicker set-up
times and faster data
rates than analogue
connections. In order to
use an ISDN connection,
both your Internet service
provider and network
operator must support it.

•

Connection security

- Choose whether Transport Layer Security (TLS) is used for the

connection. Follow the instructions given to you by your service provider.

•

Session mode

-

Permanent

/

Temporary

.

•

Data call type

(for GSM data and high speed data only) -

Analogue

,

ISDN v.110

, or

ISDN

v.120

defines whether the phone uses an analogue or digital connection. This setting

depends on both your GSM network operator and Internet Service Provider (ISP),
because some GSM networks do not support certain types of ISDN connections. For
details, contact your ISP. If ISDN connections are available, they establish connections
more quickly than analogue methods.

•

Maximum data speed

(for GSM data and high speed data only) - The options are

Automatic

/ 9600 / 14400 / 19200 / 28800 / 38400 / 43200, depending on what you

have chosen in

Session mode

and

Data call type

. This option allows you to limit the

maximum connection speed when high speed data is used. Higher data rates may cost
more, depending on the network service provider.

Copyright © 2002 Nokia. All rights reserved.

Se

tt

ing

s

34

Note: The speeds above represent the maximum speed at which your connection
will operate. During the connection, the operating speed may be less, depending
on network conditions.

Options

→

Advanced settings

•

Phone IP address

- The IP address of your phone.

Glossary: DNS -

Domain Name Service. An
Internet service that
translates domain names
such as www.nokia.com
into IP addresses like
192.100.124.195.

•

Primary name server:

- The IP address of the primary DNS server.

•

Second. name server:

- The IP address of the secondary DNS server.

Note: If you need to enter the

Phone IP address

,

Primary name server

, or

Second.

name server:

, contact your Internet service provider to obtain these addresses.

The following settings are shown if you have selected data call and high speed data as the
connection type:

•

Use callback

- This option allows a server to call you back once you have made the initial

call, so you have a connection without paying for the call. Contact your service provider
to subscribe to this service.

Note: Charges may apply for certain types of received calls, such as roaming and
high speed data calls. Contact your GSM network operator for more information.

Note: The phone expects the callback call to use the same data call settings that
were used in the callback-requesting call. The network must support that type
of call in both directions, to and from the phone.

Glossary: PPP

(Point-to-Point Protocol)
- a common networking
software protocol that
enables any computer
with a modem and a
phone line to connect
directly to the Internet.

•

Callback type

- The options are

Use server no.

/

Use other no.

. Ask your service provider for

the correct setting to use; it will depend on the service provider’s configuration.

•

Callback number

- Key in your phone’s data phone number which the dial back server

uses. Usually, this number is the data call phone number of your phone.

•

Use PPP compression

- When set to

Yes

, this option speeds up the data transfer, if

supported by the remote PPP server. If you have problems with establishing a
connection, try setting this to

No

. Contact your service provider for guidance.

•

Use login script

- The options are

Yes

/

No

.

•

Login script

- Insert the login script.